Prandtl–Glauert transformation
The Prandtl–Glauert transformation is a mathematical technique which allows solving certain compressible flow problems by incompressible-flow calculation methods.
It also allows applying incompressible-flow data to compressible-flow cases.
Inviscid compressible flow over slender bodies is governed by linearized compressible small-disturbance potential equation:[1] together with the small-disturbance flow-tangency boundary condition.
The unknown variable is the perturbation potential
The above formulation is valid only if the small-disturbance approximation applies,[2] and in addition that there is no transonic flow, approximately stated by the requirement that the local Mach number not exceed unity.
It consists of scaling down all y and z dimensions and angle of attack by the factor of
geometry will then have normal vectors whose x components are reduced by
from the original ones: The small-disturbance potential equation then transforms to the Laplace equation, and the flow-tangency boundary condition retains the same form.
This is the incompressible potential-flow problem about the transformed
The result is the transformed perturbation potential
The physical linearized pressure coefficient is then obtained by the inverse transformation which is known as Göthert's rule[3] For two-dimensional flow, the net result is that
are the incompressible-flow values for the original (unscaled)
geometry as given above, and use the Göthert's Rule to compute the
No simple results are possible, except in special cases.
For example, using Lifting-Line Theory for a flat elliptical wing, the lift coefficient is where AR is the wing's aspect ratio.
Note that in the 2D case where AR → ∞ this reduces to the 2D case, since in incompressible 2D flow for a flat airfoil we have
The PG transformation works well for all freestream Mach numbers up to 0.7 or so, or once transonic flow starts to appear.
[2] The interest in compressibility research emerged after the WWI, when the aircraft propeller tips started to reach M=0.8.
Ludwig Prandtl had taught the transformation in his lectures about 1922, however the first rigorous proof was published in 1928 by Hermann Glauert.
[5] The introduction of this relation allowed the design of aircraft which were able to operate in higher subsonic speed areas.
[6] Originally all these results were developed for 2D flow.
Göthert eventually realized in 1946 that the geometric distortion induced by the PG transformation renders the simple 2D Prandtl Rule invalid for 3D, and properly stated the full 3D problem as described above.
The PG transformation was extended by Jakob Ackeret to supersonic-freestream flows in 1925.
Like for the subsonic case, the supersonic case is valid only if there are no transonic effect, which requires that the body be slender and the freestream Mach is sufficiently far above unity.
the PG transformation features a singularity.
In reality, aerodynamic and thermodynamic perturbations get amplified strongly near the sonic speed, but a singularity does not occur.
An explanation for this is that the linearized small-disturbance potential equation above is not valid, since it assumes that there are only small variations in Mach number within the flow and absence of compression shocks and thus is missing certain nonlinear terms.
However, these become relevant as soon as any part of the flow field accelerates above the speed of sound, and become essential near
The more correct nonlinear equation does not exhibit the singularity.
