Spatial multiplexing
Spatial multiplexing or space-division multiplexing (SM, SDM or SMX) is a multiplexing technique in MIMO wireless communication, fiber-optic communication and other communications technologies used to transmit independent channels separated in space.
In fiber-optic communication SDM refers to the usage of the transverse dimension of the fiber to separate the channels.
Multi-core fibers are designed with more than a single core.
Different types of MCFs exist, of which “Uncoupled MCF” is the most common, in which each core is treated as an independent optical path.
The main limitation of these systems is the presence of inter-core crosstalk.
In recent times, different splicing techniques, and coupling methods have been proposed and demonstrated, and despite many of the component technologies still being in the development stage, MCF systems already present the capability for huge transmission capacity.
[citation needed] Recently, some developed component technologies for multicore optical fiber have been demonstrated, such as three-dimensional Y-splitters between different multicore fibers,[1] a universal interconnection among the same fiber cores,[2] and a device for fast swapping and interchange of wavelength-division multiplexed data among cores of multicore optical fiber.
Typical MMF are currently not viable for SDM, as the high mode count results in unmanageable levels of modal coupling and dispersion.
The utilization of few-mode fibers, which are MMFs with a core size designed specially to allow a low count of spatial modes, is currently under consideration.
Due to physical imperfections, the modes exchange power and are experience different effective refractive indexes as they propagate through the fiber.
[4] The power exchange results in modal coupling, and this effect is known to reduce the achievable capacity of the fiber,[5] if the modes experience unequal gain or attenuation.
Therefore, if not compensated, the capacity increase is not linear to the mode count.
The effective refractive index difference results in inter-symbolic interference, resulting from delay spread.
[6] Mode multiplexers consist of photonic lanterns, multi-plane light conversion, and others.
Bundled fibers are also considered a form of SDM.
antennas, the maximum spatial multiplexing order (the number of streams) is, if a linear receiver is used.
streams can be transmitted in parallel, ideally leading to an
increase of the spectral efficiency (the number of bits per second per Hz that can be transmitted over the wireless channel).
The practical multiplexing gain can be limited by spatial correlation, which means that some of the parallel streams may have very weak channel gains.
receiver antennas, the input-output relationship can be described as where
An often encountered problem in open loop spatial multiplexing is to guard against instance of high channel correlation and strong power imbalances between the multiple streams.
One such extension which is being considered for DVB-NGH systems is the so-called enhanced Spatial Multiplexing (eSM) scheme.
A closed-loop MIMO system utilizes Channel State Information (CSI) at the transmitter.
In most cases, only partial CSI is available at the transmitter because of the limitations of the feedback channel.
is used to precode the symbols in the vector to enhance the performance.
Examples of the reasons are as follows: either the rank of the MIMO channel or the number of receiver antennas is smaller than the number of transmit antennas.
