Thermal pressure

In thermodynamics, thermal pressure (also known as the thermal pressure coefficient) is a measure of the relative pressure change of a fluid or a solid as a response to a temperature change at constant volume.

is the pressure required to compress the material from its volume

The second term expresses the change in thermal pressure

This is the pressure change at constant volume due to the temperature difference between

Thus, it is the pressure change along an isochore of the material.

is customarily expressed in its simple form as

Because of the equivalences between many properties and derivatives within thermodynamics (e.g., see Maxwell Relations), there are many formulations of the thermal pressure coefficient, which are equally valid, leading to distinct yet correct interpretations of its meaning.

Some formulations for the thermal pressure coefficient include:

the isothermal bulk modulus,

the constant-volume heat capacity.

The thermal pressure coefficient can be considered as a fundamental property; it is closely related to various properties such as internal pressure, sonic velocity, the entropy of melting, isothermal compressibility, isobaric expansibility, phase transition, etc.

Thus, the study of the thermal pressure coefficient provides a useful basis for understanding the nature of liquid and solid.

Since it is normally difficult to obtain the properties by thermodynamic and statistical mechanics methods due to complex interactions among molecules, experimental methods attract much attention.

The thermal pressure coefficient is used to calculate results that are applied widely in industry, and they would further accelerate the development of thermodynamic theory.

Commonly the thermal pressure coefficient may be expressed as functions of temperature and volume.

There are two main types of calculation of the thermal pressure coefficient: one is the Virial theorem and its derivatives; the other is the Van der Waals type and its derivatives.

is one of the most common formulations for the thermal pressure coefficient.

Thus, the thermal pressure of a solid due to moderate temperature change above the Debye temperature can be approximated by assuming a constant value of

[5] On the contrary, in the paper,[6] authors demonstrated that, at ambient pressure, the pressure predicted of Au and MgO from a constant value of

In addition, the authors suggested a thermal expansion model to replace the thermal pressure model.

The thermal pressure of a crystal defines how the unit-cell parameters change as a function of pressure and temperature.

Therefore, it also controls how the cell parameters change along an isochore, namely as a function of

Usually, Mie-Grüneisen-Debye and other Quasi harmonic approximation (QHA) based state functions are being used to estimate volumes and densities of mineral phases in diverse applications such as thermodynamic, deep-Earth geophysical models and other planetary bodies.

In the case of isotropic (or approximately isotropic) thermal pressure, the unit cell parameter remains constant along the isochore and the QHA is valid.

But when the thermal pressure is anisotropic, the unit cell parameter changes so, the frequencies of vibrational modes also change even in constant volume and the QHA is no longer valid.

The combined effect of a change in pressure and temperature is described by the strain tensor

is the volume thermal expansion tensor and

The line in the P-T space which indicates that the strain

is constant in a particular direction within the crystal is defined as:

Which is an equivalent definition of the isotropic degree of thermal pressure.

Figure 1 : Thermal pressure as a function of temperature normalized to A of the few compounds commonly used in the study of Geophysics. [ 3 ]
Figure 2 (a) : The lines of constant (a=b) and c cell parameters of a zircon crystal (ZrSiO4 ) passing through room T and P do not coincide with the isochore (marked in black). Figure 2 (b) : As a result of the anisotropic thermal pressure (as seen in (a)) there are significant changes in the a and c cell parameters along this isochore. [ 7 ]