Time of arrival (TOA or ToA) is the absolute time instant when a radio signal emanating from a transmitter reaches a remote receiver.
Many radiolocation systems use TOA measurements to perform geopositioning via true-range multilateration.
The true range or distance can be directly calculated from the TOA as signals travel with a known velocity.
TOA from two base stations will narrow a position to a position circle; data from a third base station is required to resolve the precise position to a single point.
TDOA techniques such as pseudorange multilateration use the measured time difference between TOAs.
This synchronization can be done in different ways: Two-way ranging is a cooperative method for determining the range between two radio transceiver units.
When synchronisation of the oscillators of the involved transmitters is not viable, hence the clocks differ, then applying the measurement as a two ways travel to the receiver and mirrored back to the transmitter compensates for some of the phase differences between the oscillators involved.
This concept is applied with the real-time locating system (RTLS) concept as defined in the international standard ISO/IEC FCD 24730-5.
[2] Assume a surveillance system calculates the time differences (
It differs from the true range between the vehicle and station
Differencing two pseudo-ranges yields the difference of the same two true-ranges.
Figure 4a (first two plots) show a simulation of a pulse waveform recorded by receivers
is such that the pulse takes 5 time units longer to reach
The units of time in Figure 4 are arbitrary.
The following table gives approximate time scale units for recording different types of waves: The red curve in Figure 4a (third plot) is the cross-correlation function
The cross-correlation function slides one curve in time across the other and returns a peak value when the curve shapes match.
Figure 4b shows the same type of simulation for a wide-band waveform from the emitter.
Figure 4c is an example of a continuous, narrow-band waveform from the emitter.
The cross-correlation function shows an important factor when choosing the receiver geometry.
There is a peak at time = 5 plus every increment of the waveform period.
To get one solution for the measured time difference, the largest space between any two receivers must be closer than one wavelength of the emitter signal.
Some systems, such as the LORAN C and Decca mentioned at earlier (recall the same math works for moving receiver and multiple known transmitters), use spacing larger than 1 wavelength and include equipment, such as a phase detector, to count the number of cycles that pass by as the emitter moves.
This only works for continuous, narrow-band waveforms because of the relation between phase
: The phase detector will see variations in frequency as measured phase noise, which will be an uncertainty that propagates into the calculated location.
Navigation systems employ similar, but slightly more complex, methods than surveillance systems to obtain delay differences.
The result yields the received signal time delay plus the user clock's bias (pseudo-range scaled by
Differencing the results of two such calculations yields the delay difference sought (
However, the final step, subtracting the results of one cross-correlation from another, is not performed.
received signal time delays plus the user clock's bias (